The part where the blade hits the base is made. Thickness of foundation is 30 mm Replace the circle cut jig with a parallel cut jig. I used T-slot track with a width of 19 mm. It also serves as reinforcement. Cut 15 mm thick plywood to the same width. Cut to the same length. Slide rail (300mm)
Brand: VADANIA
Model Number: VA1045 Width of center 60 mm, width of both sides 30 mm Reinforcing material 30 mm wide To eliminate blurring of the slide rails, plywood with a thickness of 5 mm is used.
I am making a plate that can be replaced with three different tools. Diameter 10.5mm M8 Insert Nuts 厚さ15㎜の合板 Hooks for hanging springs Diameter 10.5mm epoxy adhesive M8 Insert Nuts M8 Insert Nuts Screw to keep the height at which the blade sinks constant The spring has a wire diameter of 2 mm, a width of 20 mm, and a length of 116 mm Multitool
Brand: BOSCH
Model Number: GMF50-36 Use contour gauge Electric Drill
Brand: Makita
Model Number: 6408 Use contour gauge Makita D-08355 Flash Bit with Colo 6X10 Double Sided Tape Brand Name：日東電工(Nitto) Model Number：5000NS20 Adjust the height of the parts to be placed behind.
The miter saw clamps were made during the video in which the workbench was built. This is a magnetic edge guide This is a jig to facilitate freehand operation. Diameter 5mm Diameter 6mm M4 Insert Nuts Binding band [non-stretch] 2.5cm width
Brand: Furupa
Model Number: HSSbelt80 Screws for fixing epoxy putty Epoxy putty
Brand: Cemedine
Model Number: HC-115 Mold release agent (Silicone barrier)
Brand: GSI Creos
Model Number: VM008 Binding band [non-stretch] 2.5cm width
Brand: Furupa
Model Number: HSSbelt80 Reinforced with screws Trimmer
Brand: RYOBI(KYOCERA)
Model Number: MTR-42 A 15 mm thick board is cut to the same width Cut a circle with a diameter about 1 mm larger (because the circle shrinks by the width of the cut blade).
Diameter 6.5mm Diameter 8.5mm M6 Insert Nuts Cherry wood is used for the lever part. Make a hole to insert a 3 mm thick steel plate Before making it, I was worried about how it would vibrate, but if it is fixed firmly, it can be cut stably. Iron 20 mm wide and 3 mm thick Hole for fixing M8 threaded rod Fix with epoxy adhesive. I applied beeswax. 30 mm x 30 mm x 2 mm thick L-shaped aluminum M6 Insert Nuts A large hole is made for fine adjustment of the angle later. I use a smart plug called Gosund. The initial setup is very easy. All you need is a smartphone and WiFi. This Gosund app allows you to design your own icons. The height at which the drill is attached can be changed. If you want to add a position to be changed, add an insert nut. I want the front to be a little higher, so I glue a thin board to it with double-sided tape.
The horizontal tilt adjusts the angle with aluminum. I added the trimmings out of curiosity. It is mainly used to sharpen small parts. This slide rail can be moved in the x- and y-axis directions. It moves one millimeter per rotation of the handle..