Google subtitles Hello everyone, I'm Paulo Costa, welcome to my Channel (A_Minha_Bancada) today I'll show you how I made this fantastic wooden Mallet to do this project I will recycle this piece of wood The wood I am going to use is chestnut I'll cut the 6-inch pieces I passed the pieces on a sandpaper 80 and then glued together the glue I am going to use is UHU for fast drying wood then tightened tightly with clamps now I'll prepare the handle I cut a piece of 3.5 cm by 4.5 cm by 27 cm in length I will use this tool, one of the latest projects If you have not yet seen this project I will leave the link here I marked 9 cm and then I traced all around here I cut 0.5 cm from each side then I finished cutting with the saw now I'm going to model the hammer handle with the roller sander I marked the place of the fingers with the pencil to make a more ergonomic handle with a thick rubbing the site of the fingers and I passed a sandpaper 180 across the handle the hammer will be 7 cm tall, 6 cm wide and 12 cm in length I marked the center and scored 2 points 3 cm from the edge then I made 2 holes of 10 mm these holes are for gluing two dowels the aim is to reinforce the piece then courted by the markings I spent the piece in the roll sandpaper I marked the center and made a 30 mm hole to fit the handle I marked the center of the handle, and with a 30 mm washer I made the marking to the center made a cut around 8 cm from the top then with a chisel cut by the marking At the top of the handle I made a cut, and then put a wedge that will squeeze the cable before putting the handle on the hammer, I still made a shape all around and I passed a sandpaper 180 now I'll fit the handle I decided to glue to make the squeeze I put a wooden wedge I cut the surplus with the saw I returned to sandpaper 180, and then a 240 to finish I passed a shiny acrylic varnish, to enhance the quality of the wood and got to the end of another project ven using recycled wood I got a good result here tell me what you think about this project leave your comment If you found this project interesting leave it like if this is your first time on the channel subscribe channel, activate bell and notifications to be able to receive the next projects in first hand Now, I'll say goodbye with a big hug.
until nexte video.