to operate tool insert battery pack
after loading nails before squeezing the trigger grip the work light grip switch
on the handle to activate the nailer test the depth of the nail by driving a
nail into a scrap piece of wood of the same type as the workpiece to make
adjustments rotate the air pressure dial to increase or decrease depth of nail
head on material surface if finer adjustments are needed use the depth of
drive adjustment on the tool reinstall battery and reactivate the tool by
pressing the work like grip switch drive a test nail after each adjustment until
the desired depth is set single sequential mode drives one nail with
each pull of the trigger and is denoted by a single nail icon push the tool
against the work surface to depress the workpiece contact and squeeze and hold
the trigger to drive a nail note hold trigger until drive cycle is complete
contact actuation mode allows very fast repetitive nail placement and is denoted
by a multiple nail icon in this mode you can drive one nail with each depression
of the tool against the work surface squeeze and hold the trigger push the
tool against the work surface to depress the workpiece contact and drive a nail
note hole trigger until drive cycle is complete when the magazine is almost
empty of nails the dry fire lockout feature will not allow continued
operation to resume operation reload the tool with nails if the work contacting
element does not depress fully and the tool doesn't operate the work contacting
element is jammed remove battery and nails and clear debris the lockout
feature may be engaged due to a lack of nails add nails to fix the issue if the
tool operates properly but fasteners do not drive fully the air pressure may be
too low or the depth of drive isn't deep enough remove the battery and increase
the air pressure and adjust depth of drive accordingly as required replace
the battery and test the depth of drive the nail may be too long for wood
hardness use a shorter nail that is appropriate for the wood if the tool
operates properly but fasteners are driven to deep the air pressure may be
too high depth of Drive is too deep remove the battery and decrease the air
pressure and adjust depth of drive is required replace battery and test the
depth of drive if the tool jams frequently the nails may be the wrong
size
